Weak Spot Guide: T110E3

The T110E3 like the T95 which comes before it is an absolute monster in the frontal armor department.  Many struggle to find it’s weak spots since even the lower glacis can be difficult to penetrate(especially at close range).  This guide will help with dealing with a T110E3 from the front, sides, and rear. I did not include an angled view since if a T110E3 ever angles you simply shoot the side armor and/or the lower glacis plate closest to you.

The index at the bottom of each picture describes a few abbreviations used and also the format in which the armor details are described in. Effective Armor (EA) refers to the overall effectiveness of the armor without normalization.

World of Tanks T110E3 Weak Spots |Frontal View 1|


World of Tanks T110E3 Weak Spots |Frontal View 2|


Frontally the T110E3 is very difficult to deal with using conventional methods. The lower glacis while weak in some spots is difficult to pen for a lot of tanks and at under 50mm becomes much stronger and can bounce shells left and right. The commander’s cupola unlike the T110E4 is actually pretty damn strong and should be avoided.  This leaves you with 3 options to aim for on the front of the T110E3.  On the lower glacis closest to the tracks is the main weak spot area and the 76mm (A3) area is at the bottom of the “clips” on the lower glacis.  Moving up you have A1 which can be penetrated at close range shooting down into it, and A2 which can be penetrated by high penetration HEAT/APCR shells.  On the top of the T110E3 is a very small weak spot in A5 which is only 75mm thick but make sure not to hit the view ports or the heavily sloped roof armor.

World of Tanks T110E3 Weak Spots |Side View|


The side of the T110E3 is rather straight forward for most tanks besides scouts with low penetration.  Simply avoid shooting the track areas with no hull armor behind them and the casemate/turret section and you will be fine. Once again avoid shooting the commander’s cupola since it is still 229mm thick from the sides.

World of Tanks T110E3 Weak Spots |Rear View|


The rear of the T110E3 follows the same pattern as the side armor. Simply avoid the casemate/turret area and the tracks and you’ll be fine.

Interested in American tanks? Check out these American tank models and books on American tanks over on Amazon

6 Comments on "Weak Spot Guide: T110E3"

  1. I’m taking 50% credit for the testing of the A1, A2, A3, A4 weakspots.

    A5 is super hard to hit. When would one want to aim at it?

    • If you are under 50m since the lower glacis becomes much stronger then… Or if you have a sub 200mm penetrating gun.

  2. No wonder I could never manage to find a place to pen this tank. Those frontal weak spots are so tiny!

    • Yes they are! Very difficult to hit on a moving T110E3 but hopefully this guide will at least point you in a direction to penetrating more. They might be small…but luckily the T110E3 isn’t very fast 😉

  3. Hello thanks for weak spots 🙂 … Can you make weak spots of Object 268 ?

    You are doing great job !
    Greetings from Slovakia

    Sorry for my english

    • I’m getting to it. Takes time to do these things since I calculate the armor values for many different angles. In the mean time you will want to aim for the lower glacis/”beak” area in the frontal hull. The hatch/thing sticking out of the top is also easy to damage, just hit the main part of it and not the “wings” on either side like the AMX 50 FOCH 155.

Comments are closed.

Translate »